DUS 2693:2024, Standard Test Method for Analysis of Barium, Calcium, Magnesium, and Zinc in Unused Lubricating Oils by Atomic Absorption Spectrometry, First Edition

来源：epingalert 发布时间：2024-06-13 浏览量：*

通告成员：

Uganda

通告类型：

TBT

通告发布时间：

2024-06-13

评议截止时间：

2024-08-12

通告描述：

This Draft Uganda Standard contains test method applicable for the determination of mass percent barium from 0.005 % to 1.0 %, calcium and magnesium from 0.002 % to 0.3 %, and zinc from 0.002 % to 0.2 % in lubricating oils. Higher concentrations can be determined by appropriate dilution. Lower concentrations of metals such as barium, calcium, magnesium, and zinc at about 10 ppm level can also be determined by this test method. Use of this test method for the determination at these lower concentrations should be by agreement between the buyer and the seller. Lubricating oils that contain viscosity index improvers may give low results when calibrations are performed using standards that do not contain viscosity index improvers.

文档编号：

G/TBT/N/UGA/1945

查看文档：

原文文档翻译文档

ICS Code：

75.080 - Petroleum products in general

HS Code：

27 - MINERAL FUELS, MINERAL OILS AND PRODUCTS OF THEIR DISTILLATION; BITUMINOUS SUBSTANCES; MINERAL WAXES

通告目的：

Prevention of deceptive practices and consumer protection (TBT)
Quality requirements (TBT)

DUS 2693:2024, Standard Test Method for Analysis of Barium, Calcium, Magnesium, and Zinc in Unused Lubricating Oils by Atomic Absorption Spectrometry, First Edition

热门文章